Maximizing the efficiency of production processes

Free consultation: +38(067) 577 13 75

Strawberry processing equipment

Compare bubble and brush washing for strawberries. Decide whether the washed berries need surface water removal, manual inspection or size grading before packing or processing.

Berry processing machinery

Completed berry processing projects

Planning washing and inspection for strawberries

Comparing both washers on the same strawberries

Prepare batches with comparable ripeness and typical soil or sand. After each trial, check how well the washer cleans the fruit, whether it leaves visible marks and how it transfers the fruit at discharge. Where batches arrive at different stages of ripeness, agree on separate washing and feeding settings.

Remove surface water and inspect

If washing is followed by inspection, packing or freezing, specify how much surface water the next machine can accept. Consider a dewatering conveyor if the process calls for removing excess moisture. For manual inspection, define the belt width, the number of operators and the route for rejected fruit.

Grade and collect berries

A standalone grader is available for separating strawberries by size. For a complete layout, see the Oril Eco project in Mohyliv. The published case describes a garden strawberry sorting line designed for up to 500 kg/h. Decide on the number of outlets and collection containers based on the grades used for packing or further processing.

Construction of the bubble and brush washers

The Type 1 bubble washer has a 2 m³ bath with adjustable air flow. Its catalogue rating is up to 4 t/h. The brush washer uses bristles selected for the fruit and spray nozzles above the rollers. Soft bristles are specified for strawberries and the listed model is rated at up to 2 t/h. Check the working rate on your fruit and compare the capacity of the operations after washing.

Position inspection and surface water removal

Provide a check point after washing where an operator can see any remaining soil. If the next machine requires lower surface moisture, plan a draining zone or a dewatering conveyor. The layout should show where the water will go and how staff will access the area below the belt for cleaning.

Grader openings and collection of size grades

The strawberry grader specification lists 15, 25 and 35 mm screen openings. Compare them against the pack specification and decide where the other grades will go. Check the condition of the strawberries after washing and after passing through the grader. Measure outlet heights and allow enough access to change containers while the station is operating.

What to include when requesting strawberry equipment

  • Cultivar or size range, ripeness, stem condition and typical contamination.
  • Hourly incoming rate and container size at the inlet and outlet.
  • Target grades, manual inspection requirements and the next processing operation.
  • Water supply and drainage, transfer heights and clearance for cleaning.

Equipment for washing, inspecting and grading strawberries

OperationCatalogue equipmentDetails to confirm
Wash using adjustable air flow in a bathType 1 has a 2 m³ bath and a stated capacity of up to 4 t/h.
Remove debris with brushes and rinsingSoft bristles for strawberries. Catalogue capacity up to 2 t/h.
Remove surface water after washingConfirm the required moisture level and discharge to inspection or packing.
Remove fruit with visible defectsIdentify the inspection position after washing and the reject route.
Grade fruit before packing or processingScreen openings of 15, 25 and 35 mm. Match size grades with packaging.

Equipment selection questions

Which washer is suitable for ripe strawberries?

Start with samples representative of ripeness and soil. Compare cleaning quality, visible damage and the state of the berries at the discharge from the bubble and brush washers.

When is a dewatering conveyor useful?

Consider one where surface water affects inspection, packing or the preparation for freezing. Specify the moisture requirement of the next operation and check the fruit condition on a representative trial.

What screen openings are listed for the strawberry grader?

The catalogue model lists openings of 15, 25 and 35 mm. Supply your fruit diameter specification and a representative sample. Decide how to collect each size grade.

Why may the washer and the full line have different capacities?

The catalogue ratings describe individual washers. The actual line rate also depends on inspection, water removal, grading and container changes. The Oril Eco case describes a specific installed sorting line.

Discuss your berry processing requirements

Leave your name and phone number. If you have a specification, tell us the berry type, incoming condition, required throughput and the operation you want to carry out.

+38 (067) 577 13 75

Name and phone number are required.